XUI 1.Z.3.2. UPDATE IS NOW AVAILABLE FOR INFINIX ZERO 3 X552: DOWNLOAD IT HERE

Another good news is here again for Infinix Zero 3 users as an XUI 1.Z.3.2 update which is based on android L20160330 is now available for their device. It is a timely update that packs some new features which am going to list here.

Features Of Infinix Zero 3 New XUI Update
==> XUI updated to 1.Z.3.2.
==> Added gyroscope function.
==> Added screen recording function.
==> Added weather app.
==> Added shutdown confirm option.
==> Optimized mobile overheating during charging.
==> Improved system stability and performance.

How To Flash XUI Update On Infinix Zero 3 Devices
Note
I will advice you to backup your phone data before you carry out this flashing process. Also make sure you follow my guide carefully as i won't be blamed if you cause any damage to your device as a result of wrongful application of the procedures below.

Requirements
For X552-A1-L-20160330 version
==> Download Infinix Zero 3 OTA here
==> Download TCard here
 ==> Download XFlash here

For X552-B1-L-20160330 Version
==> Download OTA here
==> Download TCard here
==> Download SP Flash here



Before you continue, read this...
Those that are still on stock recover should use OTA or TCard version to flash via recovery. Meanwhile, if you have already rooted your phone and installed custom recovery, you are advised to make use of the popular SP Flashtool to flash the update on your device.


How To Upgrade Infinix Zero 3 XUI Update Via TCard
==> Place the Tcard update you downloaded on your SD Card (It shouldn't be kept or saved i any folder)

==> Power off your device

==> Now boot into the bootloader by holding the Power Button + Volume Up until the startup logo appears, then leave the Power Button Only and you should see the android logo.


==> Again, long-press the Power Button for about 3 seconds, then simply press the Volume Up button this time around without releasing the power button till an image like this appears.


==> Remember whenever you want to navigate around in this mode, you will make use of Volume Up ⬆ or Down ⬇ buttons so use Volume Down to navigate to "Apply update from sdcard" and tap the power button 🔲 to select it.

==> You will be welcomed into a new interface just as you can see from this image.


Now utilize the Volume down ⬇ button to navigate to Tcard update and simply tap the power button to select it

==> At this point, the installation process will start and when it is done, you will see a screen like this. Just reboot your phone and you are all done.

Remember that the rebooting process could take up to 8 minutes so there is no cause for alarm. Relax and wait patiently for it to complete.